Blum Concelo entro waste bin sets - User Guide

Contents of this Article...

  • Job Property Selections - LEGRABOX
  • Job Property Selections - MERIVOBOX
  • User Created Standard - Public Variables
  • Set cabinet width and section drawer(s)
  • Valid box heights
  • Note: Valid internal width range allowing side bore to fire

Job Property Selections - LEGRABOX

  1. Construction
  2. Materials
  3. Hardware
Legrabox.cvj [Layout] - CABINET VISION
Legrabox.cvj [Layout] - CABINET VISION
Legrabox.cvj [Layout] - CABINET VISION

Job Property Selections - MERIVOBOX

  1. Construction
  2. Materials
  3. Hardware
Legrabox.cvj [Layout] - CABINET VISION
Legrabox.cvj [Layout] - CABINET VISION
Legrabox.cvj [Layout] - CABINET VISION

User Created Standard - Public Variables

Set front and side bore depth and diameter.

Legrabox.cvj [Layout] - CABINET VISION

Set cabinet width and section drawer with appropriate height

  1. Set your cabinet width for desired bin (350mm, 400mm, or 450mm)
  2. Section drawers to suit valid box height for desired bin
  3. Drawer Properties > Drawer Box > Change Guide
  4. Navigate to Concelo Entro group and select desired bin material
Legrabox.cvj [Assembly] - CABINET VISION
Legrabox.cvj [Assembly] - CABINET VISION
Legrabox.cvj [Assembly] - CABINET VISION

Valid box heights

  • LEGRABOX (385mm, or 481mm)
  • MERIVOBOX (369mm, or 497mm)

Note: Valid internal widths

In this example for a 400mm cabinet width, the valid internal opening is from 367mm to 369mm.

  • If using 18mm carcase material, you should increase cabinet width accordingly
Legrabox.cvj [Assembly] - CABINET VISION