Adjustable Shelf Pin Options - What's Included

Contents of this Article...

  • Adjustable Shelf Part Attributes
    • Shelf Pin (Bore Repeat)
    • Shelf Pin (Type)
    • Shelf Pin (Fine Tune Up/Down Position) [CV12 only]
    • Shelf Pin (Front Margin) [CV12 only]
    • Shelf Pin (Rear Margin) [CV12 only]
  • End Orthographic View - Preview Options
    • Adjustable Pin
    • Pin Centered on Shelf
    • Pin with Shelf Bore (suits Hafele Support 282.24.720)
    • Pin with Shelf Rebate
    • Rafix Cam
  • Boring options in cabinet properties

Adjustable Shelf Attributes...

Cnr 45 and Adjustable Pins.cvj [Assembly] - Solid Ultimate

Here we look at the shelf in End Orthographic View to preview options...

a) Adjustable Pin selected...

b) Adjustable Pin Center on Shelf...

  • Your guys could groove the shelf to slip over the support pins

c) Adjustable Pin with Shelf Bore...

The Shelf Bore option defaults are set up to suit Hafele Shelf Support Nickel 5mm  - 282.24.720

d) Adjustable Pin with Shelf Rebate...

e) Cam...

f) Number of Holes per Pin - Any number is valid - 7 is entered for the following image...

Cabinet Properties > Boring...

  • Bore spacing is editable in the Assembly Construction
  • Front and rear line bore set back along with hole depth and diameter are available to be edited in Section > Properties > Boring
  • The First Hole Location will affect the shelf position if you have set your shelves to align to system holes by default