Job or Room Properties (Recommended)

• Drawer Construction (Blum Legrabox System)
• Roll Out Construction (Blum Legrabox-System)
• Drawer Material (Blum Legrabox - any selection to suit your job)
• Roll Out Material (Blum Legrabox - any selection to suit your job)
• Drawer Guides (Blum Legrabox 40kg)

Cabinet Properties

• Drawer Construction
  • Use Sink Drawer Blum Legrabox (Cs) at cabinet level when building a sink drawer cabinet
  • Use Free Drawer Blum Legrabox (Cf) at cabinet level when seeking a free drawer with Glass Sides
  • Limit drawer heights EG: Blum Legrabox (C), Blum Legrabox (K), Blum Legrabox (M), Blum Legrabox (N) etc
• Roll Out Construction
  • Select specific inner drawer heights by switching Roll Out constructions
• Drawer Guides
  • Use Blum Legrabox 70kg  on larger drawers as desired

Section Properties

• Drawer Construction - Change individual drawer constructions to control each drawer
• Roll Out Construction - Change individual inner drawer constructions to control each drawer

Space Tower - Start with an empty cabinet...

1. Section Face > Drawer
2. Section Interior > Horizontal Split
3. Place the desired number of Roll Outs
4. Move to an orthographic view > Left Click Roll Out Back > Roll Out Front Type (Connect to Outer Front)
5. 3D View after connecting Roll Out 1 & Roll Out 3 to the front - I set Roll Out 2 & Roll Out 4 to be M height and left them as internal drawers
6. Cut List
7. Right Click > Save As > Make sure to preserve the Attributes when saving the Space Tower to your library

Other Inner Drawer Front Types

Valid Front Types from the Roll Out Back Attribute List...

1. Connect to Outer Front
2. Inner Front Set
3. Wooden Front Panel Only

Sink Drawers

1. Cabinet level > Section View > Properties > Construction - Select Drawer Construction 'Blum Legrabox (Cs)'
2. Section Face into the number of Drawers desired
3. Control side widths from the Left Hand Drawer Back Attribute
4. Sink drawers are in the hardware list